Features:
- Colors: Black, Silver, White, Red, Airy Blue, Dark Champagne
- Size: 75.5*36.5*25.7mm
- Built-in 650mAh Battery
- Variable Working Voltage From 2.0V To 4.2V
- Diameter Adjustment Dial
- Height Adjust Button Matching All Styles Of Oil Atomizers
- E-Juice Level Window
- OLED Display
- 10 Seconds Preheat Function
- Micro USB Port For Charging
- No-Loaded Protection
- Low-Battery Warning
- Short Circuit Protection
What’s in the Box:
- 1 x Yocan UNI Pro Box Mod
- 1 x Magnetic Ring
- 1 x USB Charging Cable
- 1 x User Manual
Yocan Uni Pro Box Mod Manual
Powering the Yocan UNI Pro Box Mod Vaporizer
- Make sure to fully charge your Yocan Uni Pro Box Mod before use for best results.
- After the battery is charged, power the Yocan UNI Pro Box Mod Vaporizer on by pressing on the power button 5 times. Note: The power button is located at the front of the battery where you have the part where you can see the OLED screen and the “+” and the “-” buttons facing outwards. The power button is the squarish button at the front located just above the OLED screen logo.
How to Load the Yocan UNI Pro Box Mod Vaporizer
- Prepare your cartridges in flat surface to prevent it from rolling off the table.
- Grab the 510 magnetic adapter and connect it to your cartridge.
- Set the 510-threaded attachment from your cartridge to the receiving end of the magnetic adapter. Twist the magnetic adapter until tight. Note: Do not over tighten the magnetic adapter as it may cause the threads to get loose. This may cause other cartridges to experience a loose connection affecting the flow of electricity and the overall performance of the Yocan UNI Pro Box Mod Vaporizer.
- Once you have connected the adapter to the cartridge, you may insert the cartridge down to the Yocan Uni Pro Box Mod chamber until it snaps.
- Use the corresponding adjustment tools to secure the cartridge in place. The width and the girth of the cartridge can be adjusted to fit the chamber by twisting the aperture adjustment tool. Do this so the cartridge will not rattle inside the chamber. Should your cartridge be lacking in height, the height adjustment tool can be used with three height settings. Bottom, medium, and high.
How to Vape the Yocan UNI Pro Box Mod Vaporizer
- Make sure the Yocan UNI Pro Box Mod Vaporizer is fully charged and loaded with your selected cartridge before you start vaping.
- Press and hold the power button while placing your lips onto the mouthpiece and prepare to draw. When the Yocan UNI Pro Box Mod Vaporizer starts producing vapor, inhale and pull from the mouthpiece.
- Repeat this process until e-liquid is fully consumed.
Selecting the Temperature Setting for the Yocan UNI Pro Box Mod Vaporizer
The difference between Uni Pro Box Mod and its predecessor is you can select desired temperature from its settings. To do that, follow the steps below:
- Simply press the left or the right button to select voltage level. The voltage level can be adjusted in 0.1-volt increments.
- Press the power button twice to activate pre-heat mode.
Cleaning and Maintaining your Yocan UNI Pro Box Mod Vaporizer
The Yocan UNI Pro Box Mod Vaporizer is just battery with no atomizer on it. Follow the steps below to keep your Uni clean and in good condition:
- Turn off the Yocan UNI Pro Box Mod Vaporizer by clicking the power button 5 times rapidly.
- Use a dry paper towel to wipe off any residue on the vaporizer.
- Always use the dedicated charger and follow the instructions to avoid damaging your Yocan UNI Pro Box Mod Vaporizer.